Re: Table Jump Bug

On Sun, 03 Jul 2005 22:57:05 +0100, sum1_lists@yahoo.com
<sum1_lists@yahoo.com> wrote:

>
> Peter Robson wrote:
>> Irregularly and not yet pinned down to a simple test case, I am
>> suffering from (what could be called) selection point jumps in a
>> multi-page table. For example, trying to position the selection point
>> (cursor) on page 2 of the table causes the displayed table to jump
>> back to page 1 with the selection point somewhere on that page. Pages
>> 3 and 4 of the table behave normally.
>> Sometimes a document 'under construction' exhibits this problem and
>> sometimes not. I have found one case where a table preceded by nine
>> paragraph (enter) characters exhibited the problem whereas with eight,
>> there was no problem.
>> I have seen the problem with 2.2.7 on XP and 2.2.8 on W98SE.
>> Can anyone recognise this as being covered by an existing bug report
>> or is it a new one? I have briefly searched Bugzilla without finding
>> anything similar but this could well be due to my not using the
>> correct keywords!
>
> This sounds similar to Bug 8477, although I'm not sure if it's exactly
> the same problem.

I'm not sure either at this stage but it is certainly close. Thanks. I
will try to find a simple reproducible test case and then either file a
new bug or add to 8477.

-----------------------------------------------
To unsubscribe from this list, send a message to
abiword-user-request@abisource.com with the word
unsubscribe in the message body.
Received on Mon Jul 4 07:35:35 2005